NFUSED® & Fishing

NFUSED® Angler Cleaner & Lubricant

NFUSED® Cleaner
A highly effective cleaner safe for use around all moving parts in fresh and salt water fishing reels. Contains corrosion inhibitors to prevent flash rusting of freshly-cleaned fishing reels. Contains NO ammonia. After cleaning, use NFUSED® Lubricant for the ultimate lubrication and protection.


  • Water Based
  • Contains corrosion inhibitors
  • Prevents flash rusting of freshly-cleaned Equipment
  • Contains NO Ammonia
  • Can be used indoors


  • No Solvent Smell
  • Removes old oils/lubricants
  • Friendly Cleaner

fishing Reel

NFUSED® - Your new Fishing buddy
NFUSED® Lubricant

NFUSED® is a synthetic dry metal conditioner which molecularly bonds to metal making it self-lubricating under the toughest environmental conditions. Unlike traditional oils, NFUSED® protects the metal surface by a super tough regenerating hi density electro-chemical bonding process. NFUSED® is not a temporary coating. It seals and conditions all metal moving parts in fresh and salt water fishing reels leaving a “dry” lubricated surface that reduces heat, improves performance and prevents jamming, and corrosion. Ease of cleaning is an added bonus!


  • Near dry and constant lubrication
  • Minimal Material build-up
  • Highly concentrated
  • Permeates the metal surface
  • Corrosion inhibitors
  • Extreme temperature range


  • Prevents jamming
  • Longer interval between cleanings
  • Inhibits corrosion
  • Ease of cleaning
  • Improved performance
  • Doesn’t gum up
  • Performs in harsh environments

NFUSED® Instructions for Angler Applications


Spray on metal parts to dissolve and remove fouling, oil, and grease. Brush heavy deposits and reapply to rinse away fouling.
Wipe dry. After cleaning, use NFUSED® lubricant for the ultimate lubrication and protection. 


Apply a very thin film (4-6 drops of NFUSED) to cotton lint-free cloth/patch to all clean metal surfaces of the fishing reels. 
Let NFUSED®  absorb into metal for 10 to 15 minutes. Heat quickens the process such as a hair dryer, heat gun, etc. 
Let metal surfaces cool. Reapply and heat again.  After three initial applications, re-lubricate as needed. 
Wipe completely to avoid sand and dust contamination.